User's Manual

Note:
The RTP port configuration parameters must satisfy the constraints that
(RTP_MAX_PORT - RTP_MIN_PORT) is greater than or equal to 10 and less than
1000.
Note:
If there is a provisioning error, RTP_MIN_PORT is reset to the default value of 50000
and RTP_MAX_PORT is reset to the default value of 50100. An error message is
logged. The SystemConfig file stores 50000 and 50100, rather than the erroneous
configuration values, to indicate that the configuration attempt has been rejected.
• CALL_WAITING [SPEAKER | STREAM]
- SPEAKER - the call waiting tone is played on the IP Deskphone speaker. This is the
default option.
- STREAM - the call waiting tone is injected into the stream played on the transducer
in use for the active call
• DISTINCTIVE_RINGING [YES | NO]
- YES - turns on the distinctive ringing feature. This is the default option.
- NO - turns off the distinctive ringing feature.
• USE_RPORT [YES | NO]
- YES - allows the IP Deskphone to work from behind and/or in front of a symmetrical
NAT with servers and/or clients that support RFC3581.
- NO - disables implementation of support for RFC3581. This is the default option.
Note:
To provision USE_RPORT, the IP Deskphone must be rebooted after the device
configuration file is updated.
• EXP_MODULE_ENABLE [YES | NO]
- YES - the IP Deskphone detects and enables an Expansion Module.
- NO - the IP Deskphone does not detect an Expansion Module. This is the default
option.
• MAX_RING_TIME [x] — an integer between 30 and 600 that configures the number of
seconds for incoming calls to ring before ignoring them. The default value is 120.
• ENABLE_UPDATE [YES | NO]
- YES -
enables UPDATE message support and adds “UPDATE” to ALLOW header.
This is the default option.
- NO - disables UPDATE message support.
Configure the provisioning server
56 SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013
Comments? [e-mail]