User's Manual

if the customer certificates are installed. The default parameter value is no. The following
are the acceptable values for this parameter:
- NO — If there is a customer certificate installed, the downloaded file is automatically
accepted without authentication.
- YES — If there is a customer certificate installed, the downloaded file must be signed
and fully authenticated.
• PRIMARY_SERVER_PROFILE [FILENAME] — This parameter is the set of Server
Profile configuration parameters to be applied for the Primary (S1) SIP server.
- filename — the name of the Server Profile file to be applied for the Primary server; for
example, profile01.dat
• SECONDARY_SERVER_PROFILE [FILENAME] — This parameter is the set of Server
Profile configuration parameters to be applied for the Secondary (S2) SIP server.
- filename — the name of the Server Profile file to be applied for the Secondary server;
for example, profile02.dat
• TECH_SUPPORT_LABEL [label_string] — This parameter configures the label used
for the Support soft key on the licensing screen. The user can call the Technical Support
service by pressing this soft key. The default value of the label is "Support" .
— label_string - label characters. Maximum length of the string is 6 alpha-numerics
characters.
Note:
The label appears if the TECH_SUPPORT_ADDRESS parameter is defined.
• TECH_SUPPORT_ADDRESS [addr_string] — This parameter configures the URI of
the
Technical.Support service. If the IP Deskphone licensing verification fails, then special
dialog appears where the IP Deskphone user can press the Support soft key to call to
the Technical Support service (see the preceding command
TECH_SUPPORT_LABEL).
The default value is [e-mail].
• FAST_EARLY_MEDIA_ENABLE [YES|NO] — This parameter allows the administrator
to activate and deactivate the Fast Early Media option (according to RFC 3264).
The default value is NO.
- YES - activate the Fast Early Media option
- NO - deactivate the Fast Early Media option
• ENABLE_ANSWER_MODE [YES | NO] — This parameter allows the administrator to
specify if Answer-Mode is supported when registering with the proxy. The default value
is NO.
- YES - the Answer-Mode is allowed. The IP Deskphone adds the "answermode" tag
to the Support header in the REGISTER request.
Create the device configuration file
SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013 77