User's Manual

VQMon configuration commands
It is important to read How VQMon works on page
116 before configuring the VQMON
parameters.
• VQMON_PUBLISH [YES | NO] — the command that is used to enable or disable the
publish message containing the voice quality monitoring metrics sent to the Proactive
Voice Quality Monitoring (PVQMoN) collecting server.
- YES - enables VQMoN.
- NO - disables VQMoN. NO is the default.
• VQMON_PUBLISH_IP [xxx.xxx.xxx.xxx] — used to configure the IP address of the
PVQMoN server that collects voice quality monitoring metrics from the publish
message.
This IP address is used only within the report.
• LISTENING_R_ENABLE [YES | NO] — used to enable or disable the alerts based on
the Listening R Minor and Major Thresholds. The default value is vocoder-dependent,
using a scale from 1 (lowest quality) to 100 (highest quality). Currently, default values are
used based on VOCODER on a per-call basis as summarized below.
- YES - enables the sending of the alert report based on the Listening R Value.
- NO - disables the sending of the alert report based on the Listening R Value.
VOCODER_G711_ULAW
VOCODER_G711_ULAWPLP
LISTENING_R_WARN = 80
LISTENING_R_EXCE = 70
VOCODER_G723
VOCODER_FLAG_G723_RATE_53
VOCODER_FLAG_G723_RATE_63
LISTENING_R_WARN = 60
LISTENING_R_EXCE = 50
VOCODER_G729
VOCODER_PCM8
vqmonVocoderTypeUnknown
LISTENING_R_WARN = 70 (default if not
configured and unknown type)
LISTENING_R_EXCE = 60
• LISTENING_R_WARN [xx]
— the threshold to send a report on Listening R less than
[xx]. The default value is 70. Using 0 resets it to default based on far end VOCODER.
- xx - is an INTEGER value used as threshold.
• LISTENING_R_EXCE [xx] — the threshold to send a report on Listening R less than [xx].
The default value is 60. Using 0 resets it to default based on far-end VOCODER.
- xx - is an INTEGER value used as threshold.
• PACKET_LOSS_ENABLE [YES | NO] — used to enable or disable the alerts based on
the packet loss thresholds. Packet loss is the fraction of RTP data packets from the source
Configure the provisioning server
82 SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013
Comments? [e-mail]