User's Manual

• SESSION_RPT_EN [YES | NO] — used to enable or disable periodic VQMon session
reports. The default is disabled.
Both session report enable and session report interval must be configured if the
IP Deskphone software has been upgraded to SIP Release 3.0 or later. Otherwise, the
SESSION_RPT_INT default of 60 seconds is used automatically.
- YES - enables periodic VQMon session reports.
- NO - disables periodic VQMon session reports. Default is NO.
• SESSION_RPT_INT [xx] — used to specify the interval for the periodic VQMon session
report in seconds. The minimum acceptable value is 60 seconds. The maximum
acceptable value is 600 seconds. The default is 60 seconds.
- xx - is an INTEGER value in seconds.
System commands
• ADMIN_PASSWORD
[password] — used to change the default administrator password
of the IP Deskphone that is used for unlocking network menus. The default is
26567*738.
- — password - the administrator password.
• ADMIN_PASSWORD_EXPIRY [seconds] — This parameter configures the date when
the ADMIN_PWD is no longer valid and requires a new password to be downloaded from
the provisioning server.
The value specifies the expiry date in seconds (Unix Timestamp format). A simple Unix
Timestamp format converter is available at
http://www.unixtimestamp.org/.
To reset the expiry date value, use the following format:
ADMIN_PASSWORD_EXPIRY 0
• HASHED_ADMIN_PASSWORD [YES | NO]
— This parameter indicates whether the
Admin password is hashed or not. The default value is NO.
- YES – Admin password is hashed.
- NO – Admin password is not hashed.
IP Deskphone bug logging/recovery commands
• RECOVERY_LEVEL
— controls the IP Deskphone recovery if the IP Deskphone hits any
Major or Critical error. The following values are used for configuring the recovery level on
the IP Deskphone:
- 0 - IP Deskphone never recovers from any error
Configure the provisioning server
84 SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013
Comments? [e-mail]