User's Manual

Table 7: IP Deskphone configuration commands on page
86 provides a summary of the
commands that can be used in the IP Deskphone configuration file. The syntax of each
command is summarized in
User Login commands on page 86.
Table 7: IP Deskphone configuration commands
Auto login AUTOLOGIN_ID_KEY01
AUTOLOGIN_PASSWD_KEY01
User Login commands
• AUTOLOGIN_ID_KEY01
[* | xx] [userID@domain name] — This parameter is located
within the IP Deskphone-specific configuration file. This is the ID that the IP Deskphone
uses to register and authenticate. The default User ID "user1" is used if an ID is not
supplied and the IP Deskphone is not logged in.
- * - indicates that the IP Deskphone should use its mac address (lower case) as the
User ID
- xx - an ASCII string that corresponds to the User ID.
- userID@domain name – the user ID must be followed by the domain name; for
example, [e-mail]; [e-mail]
Note:
To provision AUTOLOGIN_ID_KEY01, the IP Deskphone must be rebooted after the
IP Deskphone configuration file is updated. To force a hard reboot after the
IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the
device configuration file.
• AUTOLOGIN_PASSWD_KEY01 —
This parameter is located within the IP Deskphone-
specific configuration file. There is no default password. If this parameter is blank and
AUTOLOGIN_ENABLE is configured to USE_AUTOLOGIN_ID (or 2) in the device
configuration file, the IP Deskphone does not log on.
Note:
To provision AUTOLOGIN_PASSWD_KEY01, the IP Deskphone must be rebooted
after the IP Deskphone configuration file is updated. To force a hard reboot after the
IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the
device configuration file.
Configure the provisioning server
86 SIP Software for Avaya 1200 Series IP Deskphones-Administration September 2013
Comments? [e-mail]