User guide

Installing the i2004 Internet Telephone 8
Internet Phone User Guide Nortel Networks
Initializing the i2004 Internet Telephone
When you first connect your i2004 Internet Telephone to a power source, all
hardkey indicator lights and softkey icons may flash. This indicates that the
phone has not yet been initialized. You may need to contact your system
administrator to determine the correct information to use during the initialization
procedure.
When the i2004 Internet Telephone is first powered up, you will see the
introduction screen as shown in Figure 3 below. To begin the initialization
process, you must enter a key sequence while the introduction screen appears
after powering your i2004 Internet Telephone. If the key sequence is not entered
within the first two seconds of the initialization process, your set will be initialized
with previously entered parameters.
Enter the initialization key sequence by pressing each of the four softkeys
(located at the bottom of the display screen) once, pressing from left to right.
Figure 3
Nortel Networks
To enter the
key sequence,
press in order:
1
2
3
4