User manual

Chapter 4 Avaya P460 Layer 2 Features
Redundancy CLI Commands
In order to... Use the following command...
Define/delete a redundancy entry. set port redundancy (on/off)
Enable port redundancy on the
switch
set port redundancy enable
Disable port redundancy on the
switch
set port redundancy disable
Set the minimum time that is
elapses before a Primary-Backup
switchover and the minimum time
the Primary port link has to be up
before a switch-back to the Primary
port takes place
set port redundancy-intervals
Show port redundancy
configuration
show port redundancy
• When you remove an I/O module, the port redundancy configurations are
retained.
• If you replace the I/O module with the same type, redundancy will be re-
established.
• If you replace the I/O module with a different type, the redundancy
configuration will be restored to the default values.
• Any new redundancy definitions over-ride the retained configuration.
32 Avaya P460 Configuration Guide