User manual

Chapter 5 Avaya P460 Layer 3 Features
Avaya P460 Configuration Guide 43
Basic Router Configuration
L You need to install the Layer 3 license before you can configure Layer 3
parameters.
The following example shows configuration of a basic IP interface and the routing
protocol over this interface. It is not intended to provide comprehensive
configuration information.
The example shows the following steps:
• Entering router mode
• Configuring a VLAN for a specific interface
• Enabling the required protocol
1 Enter Router mode:
L Changing the device mode requires a switch reset.
2Use the session command to switch to the router entity:
Create a router Layer 2 interface set vlan (Layer 3)
Specify the VLAN on which an IP
interface resides
ip vlan/ip vlan name
Display information about the IP
unicast routing table
show ip route (Layer 3)
Display information for an IP
interface
show ip interface
Display the status of ICMP error
messages
show ip icmp
P460-1(super)# set device-mode router
P460-1(super)# session router
Router-1(super)#
In order to... Use the following command...