Single Line Business Telephones Desk, Wall, and Trimline® Models User’s Guide 999-500-270 Issue 4 July 2003
NOTICE While reasonable efforts were made to ensure that the information in this document was complete and accurate at the time of printing, Avaya Inc. can assume no responsibility for any errors. Changes or corrections to the information contained in this document may be incorporated into future issues. HEARING AID COMPATIBILITY These telephones are compatible with inductively coupled hearing aids as prescribed by the Federal Communications Commission (FCC), except for Models 223C and 224C.
Introduction This booklet contains installation and removal instructions for standard modular desk or wall telephones. Installation of the following options requires a professional installer. • • • • Adjunct Dialer SPOKESMAN® Loudspeaker External Speakerphone Headset Adapter Contact your place of purchase for details.
Modular Outlet Requirement You must have a standard modular telephone jack, such as one of those shown below, to install your phone. If you have one of these jacks already mounted, no tools are needed. FIGURE 1 Standard Modular Telephone Jacks If you do not have a standard modular telephone jack, contact your local telephone company or Avaya Inc. for details on converting your present outlet to a modular jack.
Installation Your telephone is fully assembled except for the coiled handset cord and clear line cord. To Install Your Desk Or Trimline Telephone 1. Plug one end of the coiled handset cord into the opening in the handset. Push the plug in until it clicks (Figure 2). 2. Plug the other end of the cord into the side opening in the base. Push the plug in until it clicks. 3. Plug one end of the clear line cord into the jack in the base of the telephone. Push the plug in until it clicks.
FIGURE 3 Setting the Ringer Volume Control (Desk and Trimline Telephones) 4. Plug the other end of the cord into the telephone jack in your office. Push the plug in until it clicks. 5. Turn your telephone over or for Trimline telephones, lift the handset (Figure 3). 6. Set the ringer volume switch or thumbwheel to the setting you want.
To Install Your Wall Telephone 1. Align the wall phone plug with the jack, then line up the hole in the back of the telephone set with the rivets on the wall outlet plate. Push in and slide the telephone down into place (Figure 4). 2. Plug one end of the coiled handset cord into the jack in the handset. Push the plug in until it clicks. 3. Plug the other end of the cord into the jack in the bottom of the wall base. Push the plug in until it clicks. 4.
FCC Registration Information Statement (Part 68) The following information is applicable only to equipment connected directly to the telephone network and not to connection of stations behind terminal systems.
In compliance with the rules, you should be aware of the following: 1. Connection of this equipment to the telephone network must be through one of the standard network interface jacks listed above. These may be ordered from the local telephone company or through Avaya Inc. as your authorized agent. 2.
CAUTION The following safety information is important to you. All of the telephones listed, with the exception of message waiting models, are NOT FOR RESIDENTIAL USE. They are sold for BUSINESS SYSTEMS APPLICATIONS ONLY. Use in a residential environment could result in an electrical short circuit when the telephone wiring is set up to provide other applications, e.g. appliance control, power transformers lighting telephones, etc.
