User manual

Installation
ADPRO FastTrace, Issue 5 1 - 3
1.1 Unpacking the ADPRO FastTrace
After unpacking the ADPRO FastTrace, carefully check for any sign of damage. Any damage should be reported
before installation
to your supplier or to Vision Fire & Security directly. Check that the ADPRO FastTrace packing
carton contains the following items:
1 ADPRO FastTrace chassis
1 CD-ROM containing ADPRO Video Central Lite Software
1 Installation and Setup Manual
1 Null-modem cable 1m, (3ft)
1 9-way screw terminal plug
4 or 6 15-way screw terminal plug (Model 5005=4, Model 5010=4, Model 5020=6)
1 IEC power cord
1.2 Physical Location
The location within the protected premises of the ADPRO FastTrace should be considered carefully and the following
notes are provided for guidance.
• Physical Security - The ADPRO FastTrace should be located where it will remain secure under all
conditions, even when the premises are open or occupied. The safest place would be a room (or cabinet)
with a lockable door. It should not be visible from outside the premises and not be accessible to occupant
or visitor tampering.
• System Wiring - Ideally, the ADPRO FastTrace’s position will be close to the centre of the site wiring.
Excessive cable runs will increase the installation cost, cause voltage drops, degrade signals, and offer
greater scope for EMI/RFI (electrical interference) induced faults, tampers, and false alarms. Wiring
considerations should include the following:
• The largest wiring requirement is the coaxial camera cabling and the wiring to the alarm input
and output devices
• Mains power
• The system requires at least one video camera and associated coaxial cabling for system setup
NOTE
The ADPRO FastTrace Installation and Setup Manual is also available in PDF format
on the CD-ROM.
WARNINGS
ADPRO FastTrace equipment must be used only in an INDOOR environment.