User manual

Installation
1 - 18 ADPRO FastTrace, Issue 5
1.14 Control Outputs
Control Outputs are used to control (switch on or off) external (third-party) equipment connected to the ADPRO
FastTrace.
The Control Outputs can be used to initiate control of equipment such as lights, sirens, gates and control equipment.
1.14.1 Connecting to the Control Outputs
Control Outputs are available via screw connection strips on the rear panel. Refer to Figure 1-8 for pin connections.
Figure 1-8 - Pinouts for Control Output Connectors
A typical output circuit for an external relay is shown in Figure 1-9.
NOTE
Each Control Output can be set to be active (switch on) when an alarm event is active
on the corresponding channel or to respond to remote control via Video Central.
WARNING
Exceeding the Control Output’s maximum voltage or current rating (12Vdc, 100mA) will
damage the ADPRO FastTrace and invalidate the product warranty.
For high power/voltage equipment, suitable interface circuitry must be used between
the Control Outputs and the equipment.