User manual

Setup
ADPRO FastTrace, Issue 5 2 - 5
2.2.1.1 Installing ADPRO Video Central Lite
Start the PC and insert the ADPRO Video Central Lite CD-ROM. If the Autorun feature is used, the ADPRO Video
Central Lite setup wizard will load. If autorun is not enabled, find and run the CD-ROM file named cdmenu.exe.
Select the Install ADPRO Video Central Lite option.
Follow the setup wizard instructions and accept ALL the default settings. Exit from the menu when finished, but leave
the CD-ROM in the drive.
2.2.1.1.1 Configuring ADPRO Video Central Lite & ADPRO FastTrace
The ADPRO FastTraces User Settings menu is accessed by the ADPRO Video Central Lite software. Access can be
made in two ways, via the PC’s serial (comms) port or via the network port (refer to Section 2.2.1.1.3).
Using the Serial Port to access ADPRO FastTrace:
When using serial port connection, the 1m (3ft) null-modem cable (supplied) is used.
The serial comms (COM) port on the PC must be configured for operation as follows:
• Data rate = 115,200 bps
• Data bits = 8
• Parity = none
• Stop-bits = 1
• Flow control = hardware
IMPORTANT NOTE
Installing ADPRO Video Central Gold/Lite and ADPRO FastTrace PC Viewer simultaneously
on one PC will cause incorrect operation of Video Central. Only one version can be installed
at any given time.
If upgrading from a previous version of ADPRO Video Central or ADPRO FastTrace PC Viewer
you must uninstall the previous version first. The procedure is as follows:
1. Start the current version of ADPRO Video Central/ADPRO FastTrace PC Viewer and backup
site information and database.
2. Uninstall the current version of ADPRO Video Central/ADPRO FastTrace PC Viewer.
3. Use the above procedure to install new version of ADPRO Video Central.
ADPRO FastTrace PC Viewer is obsolete and incompatible with ADPRO FastTrace Version 1.02
and later versions.