User manual

Introduction
ADPRO FastTrace, Issue 5 vii
Summary of Limitation of Liability for Vision Fire & Security.
This ADPRO Product must only be installed, configured and used strictly in accordance with the General Terms and
Conditions and the Installation and Setup Manual available from Vision Fire & Security Pty Ltd. You acknowledge
that you have read and agree to those terms and conditions.
You acknowledge that you have been provided with a reasonable opportunity to appraise the ADPRO Product and
have made your own independent assessment of the fitness or suitability of the ADPRO Product for your purpose. You
acknowledge that you have not relied on any oral or written information, representation or advice given by or on behalf
of Vision Fire & Security or its representatives.
Vision Fire & Security has no liability to you or any person for incidental or consequential loss, expense or damages
including, without limitation, loss of business, loss of profits or loss of data. You indemnify Vision Fire & Security
for any claim, amount or liability brought against Vision Fire & Security in connection with the ADPRO Product.
You expressly agree that you assume the entire risk as to the results and performance of the ADPRO Product resulting
from the configuration of the ADPRO Product. Vision Fire & Security does not warrant, guarantee or make any
representations, either expressly or implied, regarding the current or future use, or the results of the use, of the ADPRO
Product, with respect to its correctness, accuracy, reliability, completeness, interworking, functionality, currentness or
otherwise resulting from the configuration of the ADPRO Product.
To the full extent permitted by law, Vision Fire & Security expressly excludes all conditions, warranties and liability,
whether imposed or implied by statute or by rule of law or otherwise, which are not expressly set out in the General
Terms and Conditions.
To the extent permitted by law, your sole recourse for any defect of, damage to, or performance standard of the
ADPRO Product will be under the express warranties the General Terms and Conditions (if applicable) and Vision
Fire & Security will in no event be liable to pay any amount or damages resulting from or in connection with the
ADPRO Product.
To the extent by law that any limitation or exclusion can not apply, the total liability of Vision Fire & Security in
relation to the ADPRO Product is limited to:
(a) in the case of services, the cost of having the services supplied again; or
(b) in the case of goods, the lowest cost of replacing the goods, acquiring equivalent goods or having the goods
repaired.
To the extent permitted by law, Vision Fire & Security has no liability with respect to damage to or arising out of, or
the condition or performance of, the ADPRO Product resulting from negligence or improper use, storage, installation,
configuration or handling of the ADPRO Product (where ‘improper’ includes treatment other than in accordance with
the ADPRO Manual, these terms and conditions or the in formation provided at a training session); or accident,
unforeseeable circumstances or disaster; or modifications to the ADPRO Product other than in accordance with Vision
Fire & Security' instructions; or attachment of or interoperation with features, software or products not approved by
Vision Fire & Security in writing; or where the ADPRO Product has been serviced by persons not authorized by Vision
Fire & Security in writing to service the ADPRO Product.
Lightning or Related Voltage Surges
ADPRO equipment malfunction caused by lightning or related voltage surges is specifically exempted from the
warranty conditions of Vision Fire & Security Pty Ltd.
Vision Fire & Security Pty Ltd reserves the right as to final determination of whether or not an equipment malfunction
was caused by lightning or related voltage surges.
Liability