User manual

Setup
2 - 18 ADPRO FastTrace, Issue 5
2.3.2.2.6 Initialisation String
This option is used to enter additional Hayes AT commands (in ASCII format) that may be required to configure a
modem or Hayes compatible RS232 terminal adaptor to initiate (or activate) a particular product feature or setting.
Refer to the User Manual of the particular device to obtain the required Hayes AT commands.
Note that the Hayes command prefix (‘AT’) does NOT have to be entered at the start of an Initialisation String, as it
is automatically prefixed to the string contents by the ADPRO FastTrace software.
2.3.2.2.7 Advanced Serial Communications Settings
The Advanced Serial Communications Settings are used to configure the Point to Point Protocol (PPP) and Password
Authentication Protocol (PAP) parameters used by the ADPRO FastTrace.
PPP is the Internet standard for transmission of IP packets over serial lines (asynchronous and synchronous) and PAP
provides the security for the serial connection.
2.3.2.2.8 Local IP Address
Factory Default: 192.168.254.1
Sets the Local IP Address assigned to ADPRO FastTrace’s COMMS port. This address is used by the PPP messaging
software and is NOT the same as the Ethernet Properties setting or of any other device on the network.
NOTE
When multiple ADPRO FastTrace units are to be accessed from a single Video Central
system, each ADPRO FastTrace unit MUST have a unique Local IP Address (ie. do not
leave at the factory default address) for each serial & ethernet connection.