User manual

Setup
2 - 24 ADPRO FastTrace, Issue 5
2.3.3.2 PTZ Settings
Options: No PTZ, ADPRO Amux, Baxall ZMX, Baxall ZTX, Baxall Coax Alt, Baxall Coax Std, BBV
Coax, Burle, COHU, Conway, Diamond, Elbex, Ernitec, GPS, Grundig, Harris, JVC, Kalatel
Cyberdome, Kalatel KTD 12x, Mark Mercer, Molynx, Pacom, Pelco, Pelco Coaxitron, Pelco
Spectradome, Pelco Coax Ext, Sensormatic, Sensormatic Controller, Siemens, Synectics,
Unidex, VCL, Vicon, Video Switch, Vista Powerdome
Factory Default: No PTZ
When using Pan/Tilt/Zoom (PTZ) cameras or telemetry stations, the type of device will need to be set. Information to
control the PTZ unit will be sent via the PTZ port connector on the rear panel (refer to Section 1.12 for details).
To use a PTZ camera, individual Camera Settings require the ‘This Camera has a PTZ station’ checkbox to be set.
ADPRO FastTrace also incorporates the ability to use a ‘Down the Coax’ module to send control signals to some
telemetry camera stations, down the same coaxial cable that is used to transmit video to the ADPRO FastTrace.
This module can only be fitted at the factory or at your ADPRO service centre.
2.3.3.3 Cameras
Selecting the Cameras option displays a list of available video channels and any camera name assigned to the channel.
The number of available channels will depend on the ADPRO FastTrace Model number.
Figure 2-10 - Cameras Menu
NOTE
Please refer to PTZ Tech Tips for connection and setup information
on the ADPRO website.