User manual

Setup
ADPRO FastTrace, Issue 5 2 - 41
2.3.4.2.2 Mode Selection
Options: Use External Input, Use Calendar
Default: Use External Input
The Use External Input to Change Modes option is used to configure switching between two modes via the use of
the Mode Select Input on the rear panel of the unit (Pin 6 of the Audio Switcher connector). Of the four available
modes, any two can be assigned. For example, Mode 2 is assigned to a Closed input and Mode 3 to an Open input.
When the Mode Select Input pin changes state, so does the operational mode of the ADPRO FastTrace between Mode
2 and Mode 3.
Use the Configure button to open the Mode Selection Method dialogue box and choose which Mode is to be assigned
when the contact is OPEN and another Mode for assignment to a CLOSED contact condition.
Alternatively, the Specify Mode Changes in a Calendar option can be selected when Users require access to different
Modes on a time schedule basis. This option provides a timetable, using time blocks of 15 minutes duration, to assign
different modes to individual time blocks, or groups of blocks, to provide the ADPRO FastTrace with a great degree
of operational flexibility.
Use the Configure button to open the Mode Calendar Settings dialogue box.
2.3.4.3 Audio Behaviour
There are two ways by which audio information can be recorded by the ADPRO FastTrace and either way can be
assigned to a particular Mode. Use the Select Mode from List option to choose which Mode to configure.
Enabling the Record Audio checkbox will cause the ADPRO FastTrace to record information from either a
microphone or line input connected via the Audio Connector on the rear panel. Recording will occur when ever the
unit is using the assigned Mode and will be replayed when any camera is selected.
When an Audio Switcher is connected, the Record Audio option is used to configure which input channels will have
audio recorded when the assigned camera is selected. In this case, the audio to be recorded is connected via the Audio
Switcher Connector on the rear panel. To replay the recorded audio, the assigned camera must be selected.
2.3.4.4 Camera Behaviour
The operational behaviour of cameras connected to the ADPRO FastTrace is configured from the Camera Behaviour
options. The behaviour of a particular camera can be changed to suit different operational conditions. Different
behaviours are managed by assignment to one of the four operating Modes.
Use the Select Mode from List option to choose which Mode is to be configured, then choose the camera to configure
from Select Camera from List. Cameras that have be previously configured via Connected Equipment / Cameras,
will have their name displayed in this list. (refer to Section 2.3.3.3). Three information tabs are shown on the menu;
OPERATIONAL NOTE
The choice of a Mode Selection option will apply to ALL modes.