Instruction manual

VSSI-Pro Setup
Connect the TCPIP232 adapter to the VSSI-Pro with the provided cable(021-010-SF),
connect video, ATM LAN and power up both units.
1.Enter the VSSI-Pro Main Menu by simultaneously pressing and holding the DOWN and UP
while then press and releasing RESET Button. The main menu will be displayed as below.
So move cursor to ATM Select by press UP or DOWN button. Press SET to enter the ATM
Select Menu.
2.On ATM Select Menu, Move cursor to TCPIP Interface then press SET to enter.
3.The Menu in TCPIP Interface will be displayed as below.
4.Select TCPIP GENERIC to enter and Change the IP Address the same as ATM’s IP Address.
Example, if the ATM’s IP address is 192.168.0.141 So the address on TCPIP-232 Adapter
this menu as:
1. Exit off to return to the main menu then press RESET button to operation mode.
2. Test you transaction on ATM to verify VSSI-Pro and TCPIP-232 Adapter’s Operation.
40
IP ADDRESS 1 : 192
IP ADDRESS 2 : 168
IP ADDRESS 3 : 0
IP ADDRESS 4 : 141
EXIT
TCPIP GENERIC
TCPIP FORMAT I
TCPIP FORMAT II
TCPIP DEBUGING
EXIT
ATM SELECT
SCREEN SETUP
TEXT DISPLAY
COMMUNICATION
EXCEPTION REPORT
ALARM OUTPUTS
TEST/DEMO MODE
DOWN/UP LOAD SETUP
HELP
SDLC
BISYNC
ASYNC
CAMERA PORT
JOURNAL PRINTER
TCPIP INTERFACE
CUSTOM
EXIT
NOTE:
If you select TCPIP Format I or II and
program the IP to the TCPIP232
Adapter you can not disconnect from
the VSSI-Pro and plug direct to the
DVR. You can only do this is set for
Generic.