Instruction manual

TCPIP232 Testing

The TCPIP232 can be tested by using 2 computers in simulate mode.Connect the

equipment same as below.

This connecting diagram has no need to a Hub/Switch just use 1 Cross Over cable

and 1 Straight Through cable and use TCPIP232-PC/DVR Cable(021-037-SF) to program

IP Address same as TCPIP Server software.

1. Install TCPIP Client Tester software to the computer that simulates to be host

2. Install TCPIP Server software to the computer that simulating to be ATM that tapped data

by TCPIP232.

3. Set port Address for listening on TcpipServer(ATM).

4. Use TCPIP Client(Host) to send data to TCPIP Server(ATM) the destination IP address

and port same as TcpipServer configurations then connect and select datadump to

send to TcpipServer on File menu.

“ Downloading Firmware ” message will appear with NET LED flashing in the front panel of

TCPIP 232 until message “ Download Completed “ appear son the Hyper terminal screen.

Then power down and power up TCPIP232 again for going to the operating mode.