Instruction manual

TCPIP232 Hardware Configuration:

TCPIP232 hardware operation depends on your network connection. TCPIP232 is

able to operate with HUB and Network Switcher. There are 2 hardware configurations:

1. Mirror Mode

This Mode supports HUB and Programmable Network Switchers. The user needs to

provide a port for TCPIP232 to capture ATM transactions on the HUB and needs to mirror the

ATM LAN port for TCPIP232 port to capture data. This kind of switcher we called “program-

mable network switcher” .

2. Tapping Mode

The Tapping mode supports HUB and Typical Network Switcher. Tappping Mode cap-

tures ATM transactions by tapping receiving data at the ATM or POS only. So HUB and

Switch will not see TCPIP232 as a network device. see Figure 6

Figure 5. TCPIP232 Silkscreen (Left Corner Back)

Tapping Mode Setup. (This is a defualt from manufacturer)

1. Open JP15,JP16

2. JP6 Close 1-2,3-4,5-6,11-12

3. JP18 and JP19 Close 1-2

Mirror Mode Setup

1. Close JP15, JP16

2. JP6 Close 1-2,3-4,5-6,11-12

3. JP18 and JP19 Close 2-3