Installation Instructions

Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on the required
number of channels,modulation types and modes, it should not be necessary for the
host installer to re-test all the available transmitter modes or settings.It is recommended
that the host product manufacturer installing the modular transmitter,perform some
investigative measurements to confirm that the resulting composite system does not
exceed the spurious emissions limits or band edge limits(e.g.,where a different antenna
may be causing additional emissions).
b) The testing should check for emissions that may occur due to the intermixing of
emissions with the other transmitter, digital circuitry,or due to physical properties of the
host product(enclosure). This investigation is especially important when integrating
multiple modular transmitters where the certification is based on testing each of them in
a stand-alone configuration. It is important to note that host product manufactures
should not assume that because the modular transmitter is certified that they do not
have any responsibility for final product compliance.
c) If the investigation indicates acompliance concern the host product manufacture is
obligated to mitigate the issue. Host products using a modular transmitter are subject to
all the applicable individual technical rules as well as to the general conditions of
operation in Sections 15.5,15.15,and 15.29 to not cause interference. The operator of
the host product will be obligated to stop operating the device until the interference has
been corrected.
Additional testing, Part 15 subpart B disclaimer
The final host/module combination need to be evaluated against the FCC Part 15B
criteria for unintentional radiators in order to be properly authorized for operation as a
Part 15 digital device.The host integrator installing this module into their product must
ensure that the final composite product complies with the FCC requirements by a
technical assessment or evaluation to the FCC rules, including the transmitter operation
and should refer to guidance in KDB 996369.
This appliance and its antenna must not be co-located or operation in conjunction with
any other antenna or transmitter.