Always here to help you Register your product and get support at www.philips.
2 General description 1 Introduction 3 2 General description 3 3 Preparing for use 4 4 Using the appliance 6 5 Features 8 6 Cleaning and maintenance 12 7 Storage 12 8 Ordering accessories 12 9 Assistance 12 10 Warranty 13 11 Frequently asked questions 13 1 Introduction Congratulations on your purchase and welcome to Philips AVENT! To fully benefit from the support that Philips AVENT offers, register your product at www.philips.com/welcome.
3 Preparing for use IMPORTANT: Read the important safety instructions carefully before you use the video baby monitor and keep them for future reference. Hereby, Philips Electronics UK Limited, declares that this Baby Monitor is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the EC Declaration of Conformity (DoC) is available on CDROM or from website: www.philips.com/ support.
2 Insert the rechargeable battery. 3 D Note: Make sure the + and - poles point in the right direction. Reattach the lid. E N GL IS H 3.2 Parent unit 3.2.1 Operation on rechargeable battery B Warning: Unplug the parent unit and make sure your hands and the unit are dry when you insert the rechargeable battery. •• The parent unit comes with a rechargeable Li-ion polymer 1100mAh battery.
4 Using the appliance 1 •• When the battery is fully charged, the battery symbol at the top of the video display is full. •• When you charge the parent unit for the first time or after a long period of disuse, turn it off and let it charge continuously for at least 4 hours. •• Charging normally takes 2.5 hours, but it takes longer when the parent unit is turned on during charging. To keep the charging time as short as possible, turn off the parent unit during charging.
Press and hold the on/off button on the parent unit. E N GL IS H 3 4.1 Positioning the baby monitor •• The video display goes on and the linking image appears on the display. •• When a connection has been established, the baby is shown on the video display and the signal strength symbol appears. E Tip: Find out what the best position is for the parent unit by looking at the signal strength symbol. The number of stripes indicates the quality of the connection.
For more information on the operating range, see section ‘Operating range’ below. 4.1.1 Operating range E Tip: Use the provided template, to mark the exact location of the screw holes on the wall. 3 E Tip: Position the baby unit at a higher level to get a good overview of the baby’s bed or playpen. Adjust the baby unit in a way that ensures the best visibility of your baby. The operating range of the baby monitor is 150 meters (490 feet) in open air and line of sight.
D Note: If the volume is set to a high level, the parent unit consumes more power. 5.2 Adjusting display brightness 5.3 Sound level lights The parent unit continuously monitors the sound level in your baby’s room and the sound level lights let you know if there is any activity. If your baby cries, the blue sound level lights light up on the parent unit. •• As long as no sound is detected, the sound level lights are out.
•• The voice activation light on the parent unit goes on and the voice activation image appears on the video display. 2 2 •• When the baby unit detects a sound, the video display on the parent unit automatically goes on to show the baby. When no new sound is detected for 20 seconds, the video display goes out again. To deactivate the voice activation mode, press the voice activation button on the parent unit again.
D Note: The display is black and white when the infrared lights are on. However, sometimes it is possible to see a greenish image. This is normal due to external light sources. E N GL IS H D Note: 5.9 Belt clip/stand 3 4 You can also select the repeat symbol to play all lullabies repeatedly in a loop. Press the lullaby play/stop button on the parent unit to play the lullaby selected. •• The lullaby starts to play on the baby unit and is repeated continuously.
5.11 Reset feature This feature allows you to reset the settings of parent unit. You can use this function if problems occur that you cannot solve by following the suggestions in chapter ‘Frequently asked questions’. 1 Press and hold the on/off button on the parent unit to turn it off. 2 Press and hold the volume down button and simultaneously press and hold the on/off button until a beep is heard. The parent unit turns on again. •• The parent unit has now been reset to default factory settings. 5.11.
10.0.1 Full two year warranty Philips Electronics North America Corporation(USA) and Philips Electronics Ltd (CANADA) warrant each new Philips AVENT product, model SCD603, against defects in materials or workmanship for a period of two years from the date of purchase, and agree to repair or replace any defective product without charge.
•• Perhaps the baby unit is not connected to an electrical outlet and the non-rechargeable batteries in the baby unit are empty or there are no non-rechargeable batteries in the baby unit at all. Connect the baby unit to an electrical outlet or put new non-rechargeable batteries in the baby unit. Then set the on/off switch of the baby unit to ON position to establish connection with the parent unit.
Why does the parent unit react too quickly to other sounds? •• The baby unit also picks up other sounds than those of your baby. Move the baby unit closer to the baby (but observe the minimum distance of 1 meter (3.5 feet)). Why does the parent unit make a buzzing sound? •• Interference may occur when the parent unit is out of range of the baby unit. Interference may also occur if there are too many walls or ceilings between the parent unit and the baby unit or when other 2.
Why do I get interference on the parent unit? •• Interference may occur when the parent unit is out of range of the baby unit. Interference may also occur if there are too many walls or ceilings between the parent unit and the baby unit or when other 2.4GHz wireless devices are turned on (e.g. microwave, Wi-Fi router). Put the parent unit in a different place, closer to the baby unit, or turn off other wireless devices.
www.philips.com/AVENT Philips Consumer Lifestyle BV Tussendiepen 4, 9206 AD Drachten, Netherlands Trademarks owned by the Philips Group. ©2014 Koninklijke Philips N.V. All rights reserved 4222.005.0391.
