HDM-C6VWIP Video-Over-IP Matrix System Control4 Driver User Guide Version 1.
Avenview HDM-C6VWIP Control4 Driver User Guide Introduction This driver has been designed to provide two-way control of an Avenview HDM-C6VWIP HDMI-over-IP video matrix system, via TCP/IP. This driver has been written and tested using the following products: Avenview HDM-C6VWIP Controller (System FW v2.1.5(v1.4.1)) Avenview HDM-C6VWIP-S Avenview HDM-C6VWIP-R Cisco SG500-52P Driver release version: 1.
Avenview HDM-C6VWIP Control4 Driver User Guide Figure 1: Avenview CTL Settings It is additionally necessary to configure an Alias (name) for each transmitter (input) device and each receiver (output) device. Access the web interface as described above, this time choosing the TX/RX Settings tab. Note that the current device names are displayed in Device Settings at the top of the page.
Avenview HDM-C6VWIP Control4 Driver User Guide You can edit the device name in the Alias field, clicking Apply when done. Note that the name must comply with the following conventions: For Transmitter (input) devices: For Receiver (output) devices: IN[number]-[name] OUT[number]-[name] It is important that each name begins with “IN” or “OUT”, which is then followed by the input or output number.
Avenview HDM-C6VWIP Control4 Driver User Guide Figure 4: Driver Properties The driver features a number of properties that report status or control configuration. Note that the Serial Port Settings Types provide a way of defining the settings for a serial port, which can then be applied to the serial ports of multiple inputs and outputs. Property Description Driver version The version of the driver. Should be 100 for version 1.00.
Avenview HDM-C6VWIP Control4 Driver User Guide Driver Commands The driver features a number of device-specific commands used for control. Wherever a list of inputs or outputs is required, rhese can be comma separated (e.g. 1,2,3,4) or defined as a range (e.g. 1-4), or a combination of the two (e.g. 1,2-4).
Avenview HDM-C6VWIP Control4 Driver User Guide Create Multi-Host Video Wall Switch Multi-Host Video Wall Reset Input RS232 Command String RS232 Custom Command String down. Can be negative for left and up. Must be a multiple of 8 (will be rounded to the nearest if not). Horizontal/Vertical Overscale Factor – Number of columns and rows by which to overscale the image.
Avenview HDM-C6VWIP Control4 Driver User Guide Driver Variables The driver features a number of variables, providing feedback from the Avenview system. Variable Description INxxx_Name The name defined for a particular input in the Avenview system. OUTxxx_Name The name defined for a particular output in the Avenview system. Table 3: Driver Variables The names are taken from the part after the dash in the codename (see the above section entitled “Avenview Configuration” for more information).
