User guide

Avenview HDM-C6VWIP
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2014
1
Introduction
This driver has been designed to provide two-way control of an Avenview HDM-C6VWIP
HDMI-over-IP video matrix system, via TCP/IP.
This driver has been written and tested using the following products:
 Avenview HDM-C6VWIP Controller (System FW v2.1.5(v1.4.1))
 Avenview HDM-C6VWIP-S
 Avenview HDM-C6VWIP-R
 Cisco SG500-52P
Driver release version: 1.0
Avenview Configuration
It is recommended that the Avenview HDM-C6VWIP system be installed, configured and
tested by a suitably qualified engineer, according to Avenview documentation, prior to
integration with this driver. Some additional, specific configuration is required to ensure
correct operation of the driver:
The Avenview HDM-C6VWIP Control Interface Telnet Client must be configured with a static
IP address in the same range as the Control4 processor in order for the two to
communicate:
1. Enter the IP address of the HND-IP-CTL into the web browser of a computer
connected to the same network, to display the Web Interface (the default IP address
is “192.168.11.243” and default password is “admin”).
2. Choose the CTL Settings tab.
3. Enter the static IP address information into the IP Setup [Telnet client and
browser communication] section, and click Apply.