User guide

Avenview HDM-C6VWIP
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2014
5
Driver Commands
The driver features a number of device-specific commands used for control. Wherever a list
of inputs or outputs is required, rhese can be comma separated (e.g. 1,2,3,4) or defined as
a range (e.g. 1-4), or a combination of the two (e.g. 1,2-4).
Command
Description
Save Preset
Save all or part of the current input to output switching
configuration as a preset.
Preset Choose a preset number.
Outputs The output numbers whose configuration should be saved.
An empty list will save everything.
Recall Preset
Restore the input to output switching configuration saved as a
preset.
Preset Choose a preset number to recall.
Switch Multiple
Outputs
Switches all listed ouputs to the given input.
Input input to show.
Outputs list of outputs to switch to that input.
Tile Multiple Inputs On
Output
Tiles the list of inputs on the given output.
Inputs inputs to show.
Output output on which to show the inputs.
Create Video Wall
Define a video wall using a single host (input).
Wall Name Choose a wall name (this is important as other
commands refer to this name).
Size The video wall screen configuration expressed as w,h or wxh.
For example 2x2 creates a 2 x 2 (4 screen) video wall.
Input The input to show on the wall.
Outputs The output numbers used to create the video wall. This
field must contain a number of outputs equal to the amount defined
in the Size field.
Switch Video Wall
Switch a video wall to show a new input.
Wall Name The wall to switch, defined previously with Create
Video Wall.
Input The new input to shown on the wall.
Set Bezel Gap
Define the size of the TV frame (video edge) to correct for large
bezel screens in video wall mode.
Wall Name The wall to configure, defined previously with Create
Video Wall.
Screen Outside Width, Height – the overall size of the television
in mm (e.g. “600,550”).
Screen Image Width, Height – the size of the actual screen in
mm (e.g. “550,500”).
Set Picture Parameters
Define picture adjustment parameters for a video wall. Setting any
parameter to zero leaves it unadjusted. Refer to Avenview
documentation.
Wall Name The wall to configure, defined previously with Create
Video Wall.
Pixel Shift Right, Down – Number of pixels to shift right and