User guide
Avenview HDM-C6VWIP
Control4 Driver User Guide
Janus Technology Ltd
Copyright © 2014
6
down. Can be negative for left and up. Must be a multiple of 8 (will
be rounded to the nearest if not).
Horizontal/Vertical Overscale Factor – Number of columns and
rows by which to overscale the image.
Tearing Delay – the tearing delay to apply
Outputs – which outputs should use the given values
Create Multi-Host
Video Wall
Define a video wall using multiple hosts (inputs).
Wall Name Choose a wall name (this is important as other
commands refer to this name).
Size The video wall screen configuration expressed as w,h or wxh.
For example 2x2 creates a 2 x 2 (4 screen) video wall.
Inputs The inputs to show on the wall. There must be one per row.
Outputs The output numbers used to create the video wall. This
field must contain a number of outputs equal to the amount defined
in the Size field.
Switch Multi-Host
Video Wall
Switch a multi-host video wall to show new inputs.
Wall Name The wall to switch, defined previously with Create
Multi-Host Video Wall.
Inputs The new inputs to shown on the wall. There must be one
per row.
Reset Input
Reset a transmitter (input), e.g. to clear a fault.
Input The input to reset.
RS232 Command
String
Send a string to one or more serial ports. Note that due to
current protocol limitations only human readable text not
including " (double quote) or & (ampersand) can be sent.
The serial settings used will be taken from the driver properties
corresponding to the given inputs and outputs.
Inputs list of input serial ports to which to send the string.
Outputs list of output serial ports to which to send the string.
CR Termination whether to terminate the string with a carriage
return.
Command the string to send.
RS232 Custom
Command String
Send a string to one or more serial ports. Note that due to
current protocol limitations only human readable text not
including " (double quote) or & (ampersand) can be sent.
Custom serial settings are specified.
Inputs list of input serial ports to which to send the string.
Outputs list of output serial ports to which to send the string.
Serial Settings the serial settings to use in the form <baud>-
<data bits><parity><stop bits> e.g. 9600-8n1.
CR Termination whether to terminate the string with a carriage
return.
Command the string to send.
Table 2: Driver Commands