Specifications
www.avenview.com
8
1.7.3 Dip Switch for EDID & Audio Settings
DIP Switch Position
Video
Audio
Description
PIN # 1
PIN # 2
OFF
OFF
1080p
Stereo
1
Default Mode
2
: Up to 1080p & Stereo output.
OFF
ON
720p/1080i
Stereo
Safe Mode
3
: Forces system to output at 720p/1080i
with Stereo Audio.
ON
OFF
Bypass
4
Bypass
EDID Learning Mode
5
: for learning EDID from the
display while playing any received HDMI Audio format.
ON
ON
Bypass
Stereo
EDID Learning & Stereo Mode: For learning EDID from
the display while enforcing stereo output.
1 Pin-1 and pin-2 are for HDMI INPUT 1; while pin-3 and pin-4 are for HDMI INPUT 2
2 If the HDTV shows video but without audio, please set audio mode to stereo.
3 Factory default setting is pin-1 at OFF[
], pin-2 at OFF[
], pin-3 at OFF[
] & pin-4 at OFF[
]for 1080p
with stereo.
4 If you encounter any unsolved audio/video output problem during system installation, please dial the DIP
switch to pin-1 at OFF[
], pin-2 at ON[
], pin-3 at OFF[
], & pin-4 at ON[
] for safe mode to enforce the
most compatible 720p stereo output for system check. However, the safe mode cannot be initiated if your
HDMI sources are set to enforce 1080p output. In this case, please reconfigure your HDMI source to all
resolution output for troubleshooting.
5 Bypass means this device will maintain playing the original format of HDMI signals in video and perhaps
audio. By setting at this mode, the users may encounter compatibility issue among different kinds of HDMI
sources and displays. If you cannot get the audio and/or video output normally at the system installation,
please change the DIP switch setting to default mode or even safe mode to verify the functionality of the
device.
6 To learn the EDID of HDMI display for respective HDMI source devices, set (pin-1 and/or pin-3)at ON[
]
first then connect the HDTV sets to respective HDMI inputs via HDMI cables. Then please wait for 20
seconds for completing the EDID learning procedure. If you want to learn the EDID from another HDTV, you
must set pin-1 and/or pin-3) at OFF[
] first and repeat this procedure all over again.