User`s guide
www.avenview.com
14
b. According to DOS direction, Input the command: arp -s 192.168.0.123 XX-XX-XX-XX-XX-XX
(192.168.0.123 is temporary address; XX-XX-XX-XX-XX-XX is the MAC address of equipment)
c. 192.168.0.123 1
d. 192.168.0.123 based on
your existing IP schema
3.1.3 Control the Device by NET Control Command
If you need to control the SW-DVI-16X16 Matrix Switch via Internet, then the unit must connect to Internet,
and SW-DVI-16X16 must be host computer, controlling equipment must be assistant computer. Before using
command, controlling equipment need send connection request to SW-DVI-16X16 via TCP/IP protocol, and
then build a net. After that send the commands to host computer, data are all binary system, communication
command and protocol formats same as RS232 controlling format, the supporting commands are same as
3.1.4 Control the Device by WEB Interface
1. Introduction of WEB control mode
SW-DVI-16X16 has a WEB server inside, this server supplies supervision function about working state
via web. After set up a correct net control parameter (IP address), the device can be available through
HTTP.
2. Control process
Run Time Environment) inside.
3.
4. Start up browser; input IP address, like http://192.168.0.104 and then the web will display that is
inside the host computer.
3.1.5 Communication Format A
1. Format of Character All data are showed by hexadecimal data.
2. Explanation of character
The symbol,and .
3. Data length
The data must be among 0x01~0xFF excluding 0xEB, represent the quality of data 1~ data n and are
accordant with the subsequent data.
4. 0x00
It stands for any number from 0x00 to 0xFF excluding 0xEB.
Since the IP address assigned is temporary, if unit is restarted without saving the IP
address, it will be lost. To save IP address input command “telnet 192.168.0.123
9999” to save the new IP address.