User Guide

Chapter 3 System BIOS SETUP

Set up Password

1. On the initial System Setup screen, Go to Change Supervisor Password, and then press <Enter>.

2. On the following screen, enter the password and then press <Enter>.

Then enter the same password again and press <Enter>.

Enter New Password Confirm New Password

3. If you entered the correct password, the following window will appear. Press <Enter>.

The Supervisor Password is at a higher level than the User Password.

This completes setting up a password.

Password installed

[OK]

Supervisor Password is

Shows the setup status of the Supervisor Password: Installed, if a upervisor Password is set, or Not Installed.

User Password is

Shows the setup status of the User Password: Installed, if a User Password is set, or Not Installed.

Change Supervisor Password

Setting up a password helps you prevent unauthorized users from accessing the system. In the factory settings, password

is Not installed. A password can have up to six alphanumeric characters and/or numbers.