User Manual

73
- Send E-mail
Send an electronic text message. Beside the Send Email check box, click Detail.
In the E-mail Setting dialog box, click OK to exit and save the setting and Cancel to exit without
saving the setting.
(1)
(2)
(1) Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter ID and Password.
(2) Mail
Fill the mailing information.
From: Enter the sender e-mail address.
To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).
Subject: Enter the message title.
Message: Type the message.
- Start Recording
Record the video from the selected camera.
1. Beside the Start Recording check box, click
Detail.
2. In the Alarm Recording Setting dialog box,
select the camera to enable/disable video
recording. Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting
to record the number of frames based on the
Recording Setting.
4. In the Start Record prior text box, mark and
set the number in second for the program to
begin recording after the alarm has been
trigger. The time range is 1~10 seconds.
5. In the Stop Record after text box, mark and set the number in second for the program to
continue recording after the alarm has ended. The time range is 1~999 seconds. If user doesn’t
mark and set the time, the alarm recording will continue recording until alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- Send to CMS (Central Management System)