User Manual

80
Name Function
ESC on the keyboard.
(14) Event Log Show the record of activities that take place in the system
(15) Visual Search Search from a specific camera by Date, Hour, Minute, 10 Seconds and Second(see
also Chapter 7.3.1.2 )
(16) Find Next Search for the next event. You can use this when you are using Event Search
function.
(17) Intelligent Search Search the changes in the motion detector frame (See also Chapter 3.7.4).
(18) Audio Enable/disable volume
(19) De-interlace To enhance the video quality. Set the de-interlace mode to #1, if you are capturing
motionless picture and #2, if it captures lots of movement.
7.3.1.1 To Cut and Save the Wanted Portion of the Recorded Video
1. Use the Playback Control buttons or drag the bar on the playback progress bar and pause on where
you want to start the cut. Then, click Segment to set the begin mark.
2. Use the Playback Control buttons or drag the bar on the playback progress bar and pause on where
you want to end the cut. Then, click Segment to set the end mark. To cancel segmentation or set the
segment marks from the start, click Segment button again.
3. Click Output button to save the wanted clip.
4. In the Save As dialog box, locate on where you want to save the file, type the filename, and select the
video format.
7.3.1.2 To Search Using the Visual Search
1. Click Visual Search.
2. In the Visual Search Setting dialog box, select the Camera number and the date. Then click OK.
3. When a series of frames appear by date, click on the frame to display another series of frames and
search by every Hour of that date, every 3Minutes of that hour, every 10 Seconds of that minute,
every Second of that 10 seconds. To go back, click
. To view from the selected frame and close
event search, click
.