User Manual

42
3.7.2 To Cut and Save the Portion of the Recorded Video
1. Use the Playback Control buttons or drag the bar on the playback progress bar and pause on where
you want to start the cut. Then, click Segment to set the begin mark.
2. Use the Playback Control buttons or drag the bar on the playback progress bar and pause on where
you want to end the cut. Then, click Segment to set the end mark. To cancel segmentation, click
Segment button again.
3. Click Export > Output Video Clip button to save the wanted portion.
4. In the Save As dialog box, locate on where user wants to save the file, type the filename, and select
the video format.
3.7.3 To Search Using the Event Search
1. Click on the video screen on where you want to search.
2. Click Event Search. The Event Search text (red) would appear at the lower left corner of the screen.
3. In the Event Search Setting dialog box, check the type of condition you want to search. The video
search would stop at the frame that matches the condition. To keep on searching click
.
4. You may also set to search and list all the result. In the Search Duration section, set the Begin Time
and End Time. Set the Searching Interval time that system won’t list out the same events in a period
of time that user has setup. Then, click OK to start searching.
5. When the Event list appear, click and select the item you want to view.
3.7.4 To Search Using the Intelligent Search
1. Click on the video screen on where you want to search.
2. Click Intelligent Search. The Intelligent Search text (red) would appear at the lower left corner of the
screen.
3.
When the Intelligent Search Setting dialog box and motion detector frame appear, you may adjust the
sensitivity bar and the motion detector frame size and location. To set motion detector frame size and
location, left click and drag on the screen. Then, click
OK
to start searching. The video search would
stop at the frame that matches the condition. To keep on searching click
. You may also set to
search and list all the result. Just check the
List
box. In the
Search Duration
section, set the
Begin
Time
and
End Time
. Set the
Searching Interval
time that system won’t list out the same events in a
period of time that user has setup. Then, click
OK
to start searching.