User manual

ManualsBrandsAvermedia ManualsDigital Video Recorders (DVR)ESS1304 NET

OSD MENU Description

010 SEC

NOT INSTALLED

SENSOR SETUP

SENSOR REC TIME

ALARM OUT TIME

CHANNEL - 1

CHANNEL - 2

CHANNEL - 3

CHANNEL - 4

VIDEO LOSS ALARM

123 4

SENSOR REC TIME

Set the amount of time (in second) to start record when the

sensor has triggered

ALARM OUT TIME

Set the amount of time (in second) to continue sending the

alarm once triggered

CHANNEL 1~4

Customize the initial state of the attached sensor. Refer to the

table below to customize the sensor state

Condition Description

NOT INSTALLED Indicates that there is no sensor connected

NORMAL OPEN Indicates that the initial state of the sensor is

normal open. Video recording initiates when

there is a changes in the sensor state

NORMAL CLOSE Indicates that the initial state of the sensor is

normal close. Video recording initiates when

there is a changes in the sensor state

VIDEO LOSS ALARM

Select the channel when the video loss that the DVR system will send

out a alarm

1 2 3 4

MEDIUM

010 SEC

MOTION SETUP

MOTION CAMERA

SENSITIVITIY

MOTION RECORD TIME

MOTION CAMERA

Enable/disable the channel number to detect motion.

SENSITIVITY

Set the sensitivity level. The sensitivity is from H (High), 9~ 2

and L (Low).

MOTION RECORD TIME

Set the amount of time (in second) to record when motion is

detected.

123 4

0080

5005

NETWORK SETUP

IP MODE

NW ENABLE

VIDEO PORT

UPGARDE PORT

STATIC

NETWORK SETUP

Setup the network parameters for the internet or intranet remote

monitor or playback.

IP MODE

The system provides 3 types of IP setup mode – Static, DHCP,

and PPPOE.

Use

▲

and

▼

buttons to go up and down and select

MODE

, and then press

. Use

▲

and

▼

buttons to

change the selections and press

▼

to make a

selection.



STATIC:

Assigns a constant IP address for the DVR

system.

Use

▲

and

▼

buttons to go up and down

and select items, and then press

▼

to make

selection. Use

▼

and

▼

to move left and right to

select or enter the configuration value.

IP ADDRESS:

Assign a constant IP address which a real

IP addresses give from ISP to DVR system.