User manual

45
8.1.1.3 Record Setup
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Record Select
Enable/disable the channel number to record video
i
The channels which could be recorded should be enabled in the CAMERA SELECT
first.
(2) Record Mode
Select D1/CIF recording mode. Under D1 mode, the video recording is in full screen
resolution. Each channel is recorded at a maximum frame rate of 15fps. You can switch
to view the video in single full screen or 4 split screen. Whereas in CIF mode, video
recording is at a lower resolution, but each video is recorded in 30fps/25fps
(NTSC/PAL).
(3) Record Frame Rate
Set the number of frames per second to be recorded. Refer to the table below for the
available record frame rate settings. The higher the frame rate is, it uses more hard disk
space
Video Standard
Record Mode
NTSC PAL
D1 60, 20, 4 48, 20, 4
CIF 120, 60, 40, 20, 4 100, 48, 20, 4
(4) Video Quality
Select the video quality setting from BEST, HIGH, MEDIUM, GOOD, NORMAL or LOW.
(5) Auto Record
Enable/disable auto continue recording when interrupted (i.e., power breakdown, video
playback or configuration setup). It continue recording after 10 second of idleness. This