User manual

47
8.1.1.4 Alarm/Sensor Setup
(1)
(2)
(3)
(1) Sensor Setup
- Sensor Status
Customize the initial state of the attached sensor for every camera. Refer to the table
below to customize the sensor state.
Not installed: Indicates that there is no sensor connected
Normal open: Indicates that the initial state of the sensor is normal open. Video
recording initiate when there is a changes in the sensor state
Normal close: Indicates that the initial state of the sensor is normal close. Video
recording initiate when there is a changes in the sensor state
- Sensor Record Time
Set the amount of time (in second) to record after the sensor has been triggered
- Alarm Out Time
Set the amount of time (in second) to continue sending the alarm once activated
- DVR Video Loss Alarm
Enable/disable the alarm when channel video is lost. Select the channel for video
alarm loss.
(2) Mail Alarm Setup
Enable/disable alarm sending mail when alarm has triggered at the selected condition.
- HD Fail Alarm: Issue an alarm when hard disk of DVR system is failed.
- Motion Alarm: Issue an alarm when the selected channel has been detected the