User manual

English-20
4.3 Storage Device Installation
The Capture Box supports 2.5 inch internal hard drive and external USB storage device. You can save
the recorded files and snapshots either to the internal HDD or external one.
Connect your portable USB hard drive to the USB port on the front of the Capture Box
4.3.1 USB Storage Device Insertion
4.3.2 HDD Installation and Removal
It is highly recommended to use a new unformatted hard drive or a hard drive formatted as NTFS file
system. The maximum supported storage capacity of the hard drive is 2TB.
Before installing or removing the internal HDD, please disconnect the power supply from the Capture Box to avoid
data loss.
Removing internal HDD immediately after powering-off may cause personal injury due to heat. Please wait until
the HDD cools down completely (it takes approximately 10 minutes) before any attempt to remove it.
It is highly recommended to use a NTFS format hard drive instead of a flash drive to minimize the risk of recording
failure.
To avoid any possible data loss, go to main menu and press [F1] of your remote control to safely remove the
external storage disk before unplugging it from the Capture Box.