User manual

56
Power Management
To configure UPS. Click Select… to select the UPS that has connected with DVR system.
(14) System Controller Setup
To configure the parameters that is for communicating with the System Controller (an optional
accessory). Also please refer to user manual of the System Controller.
Enable – Mark the check box to enable the System Controller function.
Model – Select model of the System Controller.
Port – Select the com port that is connected with the System Controller. Click Setup to configure
com port value. The com port value is shown in below table:
Baud rate 9600
Data bits 8
Parity No
Stop bit 1
Flow control No
ID – Set an ID for DVR server (0~99). This ID is a key for communicating between the System
Controller and the DVR server.
i
When the DVR server ID is X, the DVR server can be controlled by System Controller
irrespective of the DVR ID that is selected in System Controller.