User manual

65
- Model: After selected the protocol of camera, the available model will be list in drag down list. If
user is not sure the camera is which model, click Detect Model to find the correct model of
camera. Choosing the wrong model, user is not able to continue the camera setup.
- Video Format: select format of IP camera video, if not sure, select Auto.
- Channel: assign a channel for this IP camera.
- IP Camera Site: Enter the IP address and connecting port of the camera. Through the IP
address and connecting port, the DVR system can reach and monitor the camera.
- URL: Besides the IP address, user can enter the URL of the camera, too.
- Authentication: Mark check box and enter the ID and password for authorizing to connect the
camera. Only if the camera has assign the ID and password for authentication.
- Enable Audio: Enable/disable camera audio recording.
To configure Video, Senor, Relay, and Direct Link by IE of the IP camera, click Detail. Click OK to
save the configuration and exit the setup windows. To reset the configuration back to factory value,
click Default.
i
The Video, Direct Link by IE, and Advanced Setting setup contents may be varied that
depends on the brand of IP camera supported.