Manually operated projection screen Avers Cirrus CL User’s manual Read these instructions carefully before operating the screen.
Dear Customer, Thank you very much for the purchase of our product. The manual booklet contains all operation information you may require to install properly and operate the screen. We hope it will help you to get the most performance and enjoyment of your new screen. Enjoy time with the Avers Screens product. SAFETY INFORMATION NOTICE: Important safety information. Follow the instructions described in the operating manual for safety reasons.
1.1. Declaration of Conformity CE Manufacturer’s Declaration of ConformityCE AVERS Screens Sp. z o.o.
2.2. Technical Data Projection fabrics characteristics: - Matt White E (MWE) – a special screen dedicated polyester fabric double side covered with vinyl, black back surface and white front (projection) surface, recommended for application with DLP and LCD multimedia projectors. Neutral color of the surface enables projection from any directions. Gain: 1.0, viewing angle: 150 degrees, thickness: 0,35 mm.
Pic.1 Drilling the holes for mounting anchors Pic.2 Screen ceiling installation D distance depends on the screen width: 194,8cm for Focus 18xxx 224,8cm for Focus 21xxx 254,8cm for Focus 24xxx - Fix the screen to the ceiling with anchors and screws. Check the screen case leveling before first unrolling the screen. Do not use the screen if it is not properly installed(leveled). 3.3. Wall installation - Appoint the location of the ceiling mount brackets fixing points.
4. Screen operation The screen is operated manually. 4.1 Manual operation Rolling the screen down: - Pull down the handle located at the screen lower. Keep moving down slowly to roll out the screen. - Roll down the screen until the “STOP” sign will appear. - Release the screen lower bar handle to block the screen at the position. Rolling the screen up: - Pull down the handle at the lower bar to release the rolling break mechanism.
