User's Guide

16
Problem Action
Blank labels print or 750
series errors.
Clean supply sensors.
Printer does not read or
program the RFID tag.
See your System Administrator. Make sure the
following are set correctly for your inlay (RFID tag)
type: Protocol (C1Gen1, EM4122), Read Power,
and Write Power. Refer to your RFID Setup Guide
& Supply Chart or HF Setup Guide & Supply Chart
for more information.
Common Errors
If the action does not resolve the problem, call Service at the number listed on the
inside front cover of this manual.
Error Description/Action
002 Name must be 1 to 8 characters inside quotes.
005 Supply width is invalid.
018 Code page selection defined in the field is invalid.
025 Data length is too long.
052 Data type in the RFID Data Field must be 0, 1, 2, or 3. See your System
Administrator for more information.
053 The starting block in the RFID Data Field is invalid.
101 Format referenced by batch not in memory.
226 Rule Record Line xx. Upload device must be H (Host) for Option 6.
228 Memory class identifier is invalid. The identifier must be A (AFI),
D (DSFID), or E (EAS) for Option 64. For more information, refer to the
HF Application Notes.
229 Byte code is invalid. Byte code must be an 8-bit (1 byte) character for
Option 64. For more information, refer to the HF Application Notes.
230 Lock code is invalid. Lock code must be 0 (Unlock) or 1 (Lock) for Option
64. For more information, refer to the HF Application Notes.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unnecessary formats or graphics from
memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.