User's Guide

20
RFID Supply Specifications
RFID supplies are available in a variety of sizes. Printing over the RFID inlay
causes printing irregularity. Refer to the RFID Setup Guide & Supply Chart or the
HF Setup Guide & Supply Chart for illustrations to determine which type of RFID
supplies you are using and basic printer configuration information.
Supply Types: Thermal Transfer or Thermal Direct
Die Cut or Black Mark
Supply Widths: 0.75 inch (19 mm) minimum
4.0 inches (102 mm) maximum
Supply Lengths: 1.0 inch (25.4 mm) minimum
13.0 inches (330 mm) maximum
Note: The supply length depends on the inlay selected.
Roll Inside
Diameter:
4.0 inches (102 mm)
Roll Outside
Diameter:
8.0 inches (203 mm) maximum
Ribbon Width: 4.3 inches (110 mm) for 4.0 inch (102 mm) supply
Ribbon Length: 23,600 inches (600 meters)
Additional RFID supplies may be available by request. Contact your Paxar RFID
Representative for more information.
Tag Cut Dimensions
Use these specifications for the 926™ Knife with the RFMP printer. Use only
Paxar approved RFID tag supplies.
Widths: 1.5 inches to 4.0 inches (38 mm to 102 mm)
Lengths: 1.5 inches to 16.0 inches (38 mm to 406 mm)
Thickness: 7 mils to 14 mils
Batch Separator: 3.66 inches (93 mm)
Note: The limited warranty on knives used in or with RFID printers is one (1)
year from the date of shipment, or 500,000 cuts, whichever occurs first.