User's Guide

4
802.11b/g REGULATORY
COMPLIANCE INFORMATION
This section details the regulatory compliance information specific to the wireless
components in your printer. It may not apply to other RF devices in the printer.
Refer to the documentation provided with those other RF devices for regulatory
information.
Paxar RF products are designed to be compliant with the rules and regulations in
the locations into which they are sold and will be labeled as required. The majority
of Paxar RF devices are type approved and do not require the user to obtain a
license or authorization before using the equipment. Check your local regulations
for more specific information. Any changes or modifications to Paxar equipment
not expressly approved by Paxar could void the user authority to operate the
equipment. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: Information in this document supercedes information in previous versions.
FCC RF Exposure Guidelines
To comply with FCC and Industry Canada exposure requirements, if this device is a
table-top device, it is approved for operation when there is 20 cm or more between
the antenna and the user’s body.
Declaration of Conformity for RF Exposure:
The radio module has been evaluated under FCC Bulletin OET 65C and found
compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and
15.247 (b) (4) addressing RF Exposure from radio frequency devices.
Radio Frequency Interference Requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution: The Part 15 radio device operates on a non-interference basis with
other devices operating at this frequency when using the listed
antenna.