User's Manual

2
Industry Canada
CAN ICES-3(A)
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
This radio transmitter (1502-SDCSSD40NBT) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use with
this device.
RF Exposure Guidelines
This equipment complies with RSS-102 radio frequency (RF) exposure limits
under Specific Absorption Rate (SAR) tests for portable devices operating
closer than 20 cm to nearby persons, set forth in an uncontrolled
environment. This equipment has been demonstrated to meet these RF
emissions safety limits
Labeling Requirements
The final end product must be labeled in a visible area with the following
notice:
Contains IC ID: 1502A-SDCSSD40NBT
DRAFT