User Manual

4. Clean the platen roller when you see significant adhesive build-up or a label is

wrapped around the platen

roller. Use a dry, soft-bristle

brush, such as a toothbrush, to

clean either the standard

(black) or linerless (red/orange

textured) platen roller.

If the brush does not remove

all the adhesive

♦ use isopropyl alcohol

ONLY on the standard (black) platen roller.

Moisten a cotton swab with isopropyl alcohol and run the cotton

swab across the platen roller. Turn the platen roller with your

finger to make sure the platen roller is clean all the way around.

After cleaning, feed several inches of supply through without

printing to remove any remaining isopropyl alcohol.

♦ call Service to clean the linerless (red/orange textured) platen

roller.

NOTE: DO NOT use alcohol or solvents on linerless (red/orange textured)

platen rollers.

5. Rub the cotton swab moistened with isopropyl alcohol across the peel bar and

remove any build-up.

6. Moisten another cotton swab with isopropyl alcohol. Rub the cotton swab

across the printhead and remove any build-up. You may need to use a

printhead CLEAN-STRIP if the printhead is extremely dirty or you see streaks

on the supply.

7. Rub the cotton swab across the supply sensor and die cut sensor and remove

any build-up.

8. Clean the build-up in the supply path.

Printhead

Supply

Sensor

Peel

Bar

Platen

Roller