Instruction manual

Setting the Supply Type
You can print on aperture, black mark, die cut, or continuous supplies. You
have to tell the printer which supplies you are using.
Note: If you are using edge aperture supplies, use the die cut setting.
To change the setting, from the Main Menu, select Setup, then Supply. If
password protection in enabled, press Feed/Cut three times, then press
Enter/Pause before you see the Setup Menu options. Then, follow these
steps.
1. Press » or ¼ until you see
SUPPLY
Supply Type ¼
2. Press Enter/Pause to set the supply type option. The current setting is
displayed, for example:
SUPPLY TYPE
» Black Mark ¼
3. Press » or ¼ to see the other options. After you display the option you
want, press Enter/Pause. Press Escape/Clear until you see the Main
Menu.
Setting Supply Options 4-3