User Guide

In this dialog you can further define the following parameters of the scan:

· Schedule running - specify the time intervals for the newly scheduled scan

launch. The timing can either be defined by the repeated scan launch after a

certain period of time (Run every ...) or by defining an exact date and time (

Run at specific time ...), or possibly by defining an event that the scan

launch should be associated with (Action based on computer startup).

· Advanced schedule options - this section allows you to define under which

conditions the scan should/should not be launched if the computer is in low

power mode or switched off completely.

Control buttons of the Settings for scheduled scan dialog

There are two control buttons available on all three tabs of the Settings for

scheduled scan dialog (Schedule settings, How to scan and What to scan) and

these have the same functionality no matter on which tab you currently are:

· Save - saves all changes you have performed on this tab or on any other tab

of this dialog and switches back to the AVG scanning interface default dialog.

Therefore if you wish to configure the test parameters on all tabs, press the

button to save them only after you have specified all your requirements.

· Cancel - cancels any changes you have performed on this tab or on any other

tab of this dialog and switches back to the AVG scanning interface default

dialog.