Instructions / Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
HD29248
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3. Attach the mounting screw part way into the side hole of the single bar, then
lock it securely with hex nut until becoming. Attach the single bar to the
junction box using two box screws as shown. The side of the single bar
marked “GND” must face out.
The junction box is not included.
4. Align the pipe’s (C) hole with hooks on the glass shade, attach screw (E) and
secure the connection with hex nut (D), then adjust the angle and position of
the other end of the pipe to fit the holes on canopy (A) and secure it with the
big hex cap nut.
5. While holding the shade assembly towards the ceiling, connect the electrical
wires as Shown in Fig.2, making sure that all wire nuts are secured. You may
have to wrap the connections with electrical tape. If your outlet has a ground
wire (green or bare copper), connect the fixture ground wire to it. Otherwise
connect fixture’s ground wire directly to the mounting plate with the green
screw provided. After wires are connected, tuck them carefully inside the
Junction Box.
6. Raise the shade assembly onto the junction box, aligning screws on single
bar with mounting holes in canopy(A) and lock it securely with the ball
nuts(B).
7. Install the light bulbs (Not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
Your installation is now complete. Return power to the junction
box and test the fixture.
A
D
F
B
C
E
E
D
Hex Nut
Junction Box
(Not included)
Screw
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
`
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service
at:[e-mail]
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202307HD29248
FIG.2
FIG.1