User Manual

MDR5800 User Manual

862-01881 Issue 6 Page 26

4.1 Customer Furnished Tools and Equipment

The following table lists tools and equipment required to install the MDR5800 system.

General, IU-to-OU Interconnect

• Cable cutting and stripping tools.

• Earth lug crimp tools.

• 3 mm flat screwdriver - IU to OU power cable.

• RJ45 crimp tool - IU to OU data cable.

• Earth cable or strap rated at 45A with 5 mm earth lug for earthing the Indoor and

Outdoor Units.

• Cable ties, used to secure the cables to the mast at regular intervals.

• Pozi #2 screwdriver - IU mounting in a 19" rack and the earth lug.

• 2.5mm Allen key - To change the position of the IU mounting brackets.

• DC power supply cable: minimum 2.5 mm square conductor, rated for 10 A. For

connection between the power supply and the Indoor Unit DC connector on the

rear panel.

• IU earth lug: 10-4 (10 square mm for wire and hole big enough for M4 thread)

• 13 mm spanner – used for attachment of OU to mounting bracket.

• 13 mm spanner - used for attachment of OU mounting bracket to pole.

• 2.5 mm Allen key - used to tighten OU connection box cover fasteners.

• OU earth lug: 10-8 (10 square mm for wire and hole big enough for M8 thread)

Please refer to Chapter 7 for details on the data and RF cables, which are also

customer furnished equipment.