User's Manual

ECLIPSE INSTALLATION MANUAL
Chapter 1. Introduction to
Installation
This section provides a list of recommended installation tools and materials, and a
procedure for unpacking and checking the equipment.
Eclipse has been tested for and meets EMC Di rective
89/336/EEC. The equipment was tested using screened cable;
if any other type of cable is used, it may violate compliance.
CAUTION:Eclipse is a Class A product. In a domestic environment it
may cause radio interference: be prepared to resolve this. Eclipse
equipment is intended to be used exclusively in telecommunications
centers.
WARNING: You must comply with the relevant health
and saf ety practices when worki ng on or around
Ecli pse r adio equi pment. Refer to Health and Safety on
page 5
Installation Overview
The following list provides a basic guide, in order, of an Eclipse hardware install-
ation process.
Hardware installation typically proceeds as follows:
1. Pre-Installation
l Unpack equipment - see Unpacking on page 42
l Verify system configuration
l Check basic components
l Check kits and accessories
2. Installation
l Antenna - refer to the antenna manufacturer's installation instructions
l ODU 600 - see ODU Installation on page 43
l INU chassis - see INU and INUe Installation on page 71
l INU plug-in cards - see Plug-in Installation on page 83
l Traffic and NMS cables - as required
For more informati on on installation practice refer to the
Aviat Networks' publ i cation 'Best Practi ces Guide'.
260-668066-004 AUGUST 2013 41