User's Manual
Table Of Contents
- Eclipse ODU 600 5.8 GHz ISM Band Installation Manual Rev.001
- Copyright & Terms of Use
- Aviat Networks Support
- Eclipse Product Compliance Notes
- Contents
- Volume I: Introduction and Safety
- Volume II: System Overview
- Volume III: Installation
- Chapter 1. Introduction to Installation
- Chapter 2. ODU Installation
- Chapter 3. INU and INUe Installation
- INU/INUe Overview
- Installation Requirements
- Installation Procedure
- Plug-in Installation
- INU/INUe Cable Assemblies
- DAC Trib Connectors and Cables
- NMS Connectors and Cables
- NMS 10/100Base-T Connector
- Maintenance V.24 Connector
- Auxiliary and Alarm Connectors and Cables
- AUX Data Cable: Async, HD26 to Wirewrap, 2 m
- AUX Data Cable: Sync, HD26 to Wirewrap, 2 m
- AUX Data Cable: Async, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Sync, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Async, AUX HD26 to AUX HD26, 1 m
- AUX Data Cable: Sync, AUX HD26 to AUX HD26, 1 m
- AUX Alarm I/O Cable: HD15 to Wirewrap, 2 m or 5 m
VOLUME III, CHAPTER 2, ODU INSTALLATION
The mount can also be used to remotely support a protected ODU pairing installed
on a coupler. The coupler connects to the remote mount assembly in the same way
as an ODU.
The remote mount clamps to a standard 112mm (4”) pole-mount, and is common to
all frequency bands. The figure below shows an ODU installed on a remote mount.
Two versions of the remote mount are available, a cast unit (as shown) and a stain-
less steel unit.
Figure 2-8. Remote Mount
Flexible waveguides are frequency band specific and are normally available in two
lengths, 600mm (2ft) or 900 mm (3ft). Both flange ends are identical, and are
grooved for a half-thickness gasket, which is supplied with the waveguide, along
with flange mounting bolts.
To prevent wind-flex, a flexible waveguide or coax must be suitably fastened or sup-
ported over its length. Where it is not possible to fasten directly to the support struc-
ture, hanger assemblies are recommended, comprising a stainless steel clamp,
threaded rod and a form-fit rubber grommet. The figure below shows a typical
assembly.
Figure 2-9. Flexible Waveguide Hanger Assembly
Flexible waveguide and hanger kit options are available.
54 AVIAT NETWORKS