User's Manual
Table Of Contents
- Eclipse ODU 600 5.8 GHz ISM Band Installation Manual Rev.001
- Copyright & Terms of Use
- Aviat Networks Support
- Eclipse Product Compliance Notes
- Contents
- Volume I: Introduction and Safety
- Volume II: System Overview
- Volume III: Installation
- Chapter 1. Introduction to Installation
- Chapter 2. ODU Installation
- Chapter 3. INU and INUe Installation
- INU/INUe Overview
- Installation Requirements
- Installation Procedure
- Plug-in Installation
- INU/INUe Cable Assemblies
- DAC Trib Connectors and Cables
- NMS Connectors and Cables
- NMS 10/100Base-T Connector
- Maintenance V.24 Connector
- Auxiliary and Alarm Connectors and Cables
- AUX Data Cable: Async, HD26 to Wirewrap, 2 m
- AUX Data Cable: Sync, HD26 to Wirewrap, 2 m
- AUX Data Cable: Async, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Sync, HD26 to 3 X DB9, 1 m
- AUX Data Cable: Async, AUX HD26 to AUX HD26, 1 m
- AUX Data Cable: Sync, AUX HD26 to AUX HD26, 1 m
- AUX Alarm I/O Cable: HD15 to Wirewrap, 2 m or 5 m
ECLIPSE INSTALLATION MANUAL
Figure 2-11. ULA Installed in Copper Plate Entryway
Item Description
1 Lightning Surge arrestor
2 Rubber seal
3 Copper entryway plate
4 Star washer and nut
5 Mastic weatherproofing
6 Cable ground kit
7 Jumper cable
8 Rack ground wire
9 Equipment rack
10 Site ground system
Procedure
Carefully knock-out or drill for an N connector in the wall entryway plate. Where
provided, select a knockout with flats.
Install the ULA using the O-ring, star washer and nut provided. Check the O-ring is
correctly located within its groove, and up against the inside face of the plate.
Trim the ODU cable to length, fit an N male connector, and attach to the ULA.
Weatherproof the external N connector assembly using mastic and vinyl tape.
Weatherproofing on page 69.
Install a jumper cable from the ULA to the indoor radio unit.
260-668066-004 AUGUST 2013 65